AMP STANDARD TEST PLAN FORMAT

From Center for Friction Stir Processing Guide

APPENDIX I - AMP STANDARD TEST PLAN FORMAT

Test Plan

AMPTP-Year-next sequential

(TITLE OF PROJECT)

Revision: New

Creation Date:

Revision Date:

Prepared By: ___________________________

(Name and Title of Preparer)

Advanced Materials Processing Center

South Dakota School of Mines and Technology

Approved By: ___________________________

William J. Arbegast

Director

Advanced Materials Processing Center

South Dakota School of Mines and Technology

1.0 SCOPE:

1.1 Application: This test plan defines the work to be performed by the South Dakota School of Mines and Technology Advanced Materials Processing (AMP) Center to (describe the test goals and the program which the tests support)

1.2 Describe the scope of the testing and the limitations on applicability (ie, what is covered in the testing and what is not covered in the testing)

2.0 APPLICABLE DOCUMENTS: The latest issue of the following documents, unless otherwise noted, forms a part of this test plan to the extent specified herein. If there is a conflict between documents, the requirements provided in this specification shall take precedence.

2.1 Government Documents: (include as applicable)

Mil-H-81200 Heat Treatment of Titanium Alloys

2.2 Industry Specifications and Standards: (include as applicable)

ASTM E 8 Test Method for Tension Testing of Metallic Materials

QQ-A-250/11 2024-T3 Aluminum Alloy Sheet

QQ-A-250/11 2024-T851 Aluminum Alloy Plates

2.3 Advanced Materials Processing Center Specifications: (include as applicable)

AMP-03-xxx Operating Procedures for the FSW Equipment

AMP-03-xxx Operating Procedures for the Interstitial Analyzer

AMP-03-xxx Preparation of Metallographic Specimens

2.4 Other Documents:

AMP-03-xxx AMP Center Safety Manual

3.0 REQUIREMENTS: The detailed requirements, as specified herein, shall be followed for all testing and evaluation of the (provide test description)

3.1 Materials: Describe the materials to be tested AND the materials needed to support the test program

3.2 Equipment: Describe the test equipment to be used.

3.3 Personnel: Describe the personnel and skill level requirements

3.4 Procedure: Describe in detail the test procedures to be used such that the test can be COMPLETELY reproduced at a future date. Include references to test specimen configurations to be included in APPENDIX A

4.0 DATA ANALYSIS: The detail requirements and procedures for data collection and data analysis are described here. Include discussion of anticipated results.

5.0 ACCOUNT NUMBER: Provide the contract name and account number here.

6.0 TECHNICAL POINT OF CONTACT: Provide the lead engineer name, phone number and organization here

APPENDIX A:

Include drawings of test specimens and schematics of test setup when appropriate